Beloit Jones 34 Inch DD Model 3500 Disc Refiner. Recently Upgraded From A 3000 Series This Refiner Is Electro Mechanically Actuated And In Good Condition. Upgraded In 2005.
20' Diameter Black Clawson Pulper - Black Clawson; Capacity: 425 TPD at 3%; Hymac Turboflex Retrofit; Low Consistency Type: Continuous; Construction Material: Stainless Steel Interior and Exterior; One (1) Pulper Bottom Accept Chamber; One (1) Pulper Tub In Three (3) Sides Upright; One (1) Vokes Rotor 87-87.5" 8-Vanes S/S; One (1) Plug Made Of Carbon Steel; Four (4) Pulper Legs; One (1) Wear Plate; One (1) Extraction Plate. Spares Parts Available Separately: Vokes Rotor (2) Extraction Plates 3/8' and 1/2" Holes Gearbox Rotor Hub and Wear Plate.
45-1B Disk Refiner Andritz 3000 HP Completely Rebuilt. To Include: Disassembly inspection and rebuild of the Rotor Sleeve Fit Stator Disc Face Base with new custom oil hoses FE Pedestal TE Pedestal Swing Door / Plate Holder Plate Adjusting Assembly Rotary Air Seal Door Throat Liner Bearings. 45-1B Refiner General Overhaul Operations: Steam clean the interior and exterior of oil tank of base. Sandblast and coat with rust preventive. Plane both top and bottom surfaces to within .002 T.I.R. if necessary. Trim side register .030 to allow for alignment of stator and pedestals. Dynamically balance Rotor and Disc assembly to ISO standard G1.0. Qualify all bearings for optimum mounted internal clearance. Assemble bearings housings and seal assemblies on the shaft and set thrust bearing end play. Assemble the refiner complete installing new oil piping hoses and drains. Connect oil system and fill tank with oil for test running. Test run refiner for 1 hour to establish assembled refiner vibration and bearing sound levels. Paint and detail all parts. Prepare refiner for delivery to customer.
Beloit 44" 304 SS Model 4996 Belcor detrasher. 250HP V-Belt Drive. Manufactured 1981. Chamber capacity approximately 90 Cu. Ft. (2.55 cu.m.). Low profile impeller. Extraction plate with 5/32" (3.97mm) diameter holes. 8" (203mm) inlet 14" (356mm) outlet 6" (152mm) drain and 6" (152mm) heavy rejects openings. Designed for 275 TPD (249MTPD) 3 - 3 ½ % consistency but capable of doing up to 465 tpd (421 MTPD) depending on the application.